The Short Answer
Ripping Stikwood to width is usually needed when the final row is too wide for the remaining space. Measure the gap, mark a rip line, cut the plank to fit, dry fit it, and then install. Because Stikwood is thin and lightweight, a table saw is not typically required.
When Stikwooding you will probably hit a row where the existing planks are two wide and will nee ‘ripped to width’ so they fit. This is normally the last row if an install. Don’t worry, you won’t need a table saw like most wall panels. Because Stikwood thin and lightweight, you can easily cut it with a jigsaw (some people even use a utility knife). The tutorial below walks you through ripping a plank to width.
Step 1—Measure and Mark
Step 2—Draw Your Rip Line
Step 3—Cut
Depending on the length of your piece , Stikwood can be ripped to width with either a jigsaw, utility knife, or a table saw. Start your rip from the mark and follow the line.
Step 4—Dry Fit and Install
Before installing your ripped piece, dry fit the Stikwood into place. Dry fit means assembling the piece(s) of a project to check their fit before application. If the piece fits, remove the adhesive strips and install. Secure your piece into place with the J roller.
